MP 2128heli for Drone

[ฺิBoonsarm Pooalai]

Hi guy

Now I have MP2128g2 use for my Fix wings but, I have plan to make Drone for Inspection

I have a question

1. Can I use MP2128heli to replace the DJI board in the M600 model?
2. In the auto flight Can fly to set WPT vertically?
3. Is there any place to make a Drone that uses micropilot?

Thanks for all answer

Sammy

[Evan Schellenberg]

Hello Sammy,

1. The autopilot could control the air frame itself, but it may not be compatible with the existing DJI electronics. The autopilot uses PWM for controlling the ESCs, and I can't say for sure if the DJI ESCs will be compatible. They may use a different type of signal in which case they won't be compatible.
I also don't know the details on the radio modems or RC receiver is used in the M600 so I can't say for sure if they will be compatible. If you replace all of the electronics and only use the air frame then it could be made to work.

2. If you right click on a waypoint and edit its properties, there is a 'Use Altitude' option that lets you set the altitude for the waypoint. This will cause the desired altitude to change to the value set when the waypoint is activated. This allows autonomous vertical control. You can also use direct 'climb' commands anywhere in the fly file to change altitude at certain points of the autonomous flight plan.

3. Are you looking for an already integrated UAV system? Our Clients page on the MicroPilot website has a small selection of our public customers. If you contact [e-mail] with more info of the type of UAV system you are looking that uses a MicroPilot autopilot for they may be able to put you in touch with other clients not listed on our webpage.

Evan Schellenberg

MicroPilot Support