MicroPilot

MicroPilot Autopilot Users Group

Hi, I use 1 battery and RC engine. RC receiver, servoboard is connected 6V BEC. I wonder if we have to cut the ground wire to use autopilot.

Comment

You need to be a member of MicroPilot to add comments!

Join MicroPilot

Comment by Evan Schellenberg on October 24, 2018 at 11:11am
Hello,
If the RC receiver and servo board are powered from the same battery as the autopilot, then you do not need any extra ground wires to go with the signals. So the servo board to autopilot ground line on the P1 connector should be disconnected, and the RC receiver to autopilot connection does not need a ground.

Share

© 2018   Created by MicroPilotNingAdmin.   Powered by

Report an Issue  |  Terms of Service